靜電除塵器用吊裝轉動瓷瓶用于靜電除塵器電暈極側部傳動振打清灰裝置，起傳動和絕緣作用。

瓷絕緣子適用于工作溫度不超過250℃、直流工作電壓72KV～100KV，安裝地點海拔高度不超過1000米的工作條件下使用?？古て茐呢?fù)荷不低于1000N.m。

瓷絕緣子嚴格按照GB/T772-2005《高壓絕緣子瓷件技術條件》和B/T6746。3-1993《靜電除塵器用瓷絕緣子》制造。瓷件表面施白釉或棕釉。

注：不同瓷質等級的瓷件耐溫≤250℃、≤350℃、≤500℃、環境中使用，工作電壓為72-120KV

使用各種瓷瓶絕緣子產品時必須安裝平整受力均勻，運行設備前先給瓷瓶及安裝位置加熱烘干12-24小時左右（保證瓷瓶及安裝位置清潔干燥，不能有油污等潮濕現象，檢查電壓是否符合要求）才能運行設備），突然升溫降溫會導致溫差引起瓷瓶炸裂。

Lifting and rotating porcelain bottles for electrostatic precipitators are used to drive the rapping and ash cleaning device at the corona electrode side of the electrostatic precipitator, which plays a driving and insulating role.

Porcelain insulators are suitable for use under working conditions where the working temperature does not exceed 250 ℃, the DC working voltage is 72KV to 100KV, and the altitude of the installation site does not exceed 1000m. The torsional failure load shall not be less than 1000N. m.

Porcelain insulators shall strictly comply with GB/T772-2005 Technical Conditions for High Voltage Insulator Porcelain Components and B/T6746. Manufacture of Porcelain Insulators for Electrostatic Precipitators (3-1993). The surface of porcelain pieces shall be painted with white or brown glaze.

Note: Porcelain parts with different porcelain grades can withstand temperatures ≤ 250 ℃, ≤ 350 ℃, ≤ 500 ℃, and be used in environments with a working voltage of 72-120KV

When using various porcelain insulator products, it is necessary to install them smoothly and evenly under uniform stress. Before operating the equipment, heat and dry the porcelain bottle and installation location for about 12-24 hours (ensure that the porcelain bottle and installation location are clean and dry, free of moisture such as oil stains, and check whether the voltage meets the requirements) before operating the equipment. Sudden temperature rise and drop can cause the porcelain bottle to explode due to temperature differences.